Steel bulb nr3


Jari made this steel bulb over the weekend. It has a slightly triangular cross section in the beginning which flattens out to a 'beaver-tail' at the end.

3 thoughts on “Steel bulb nr3”

  1. If you were to make a steel bulb the same size as a lead bulb, how much differance would it weight? Or how much bigger would it have to be to weight the same as a lead buld. Maybe you could take a picture of a lead and steel bulb side by side.

  2. Hi Andrew,

    I don't have the CAD files for the two bulbs here right now. A quick calculation goes something like this.

    We want the bulb to weigh say 2400 g.
    If made from pure lead with a density of 11.34 kglitre then the volume should be 0.211 litres.
    If from steel with 8 kg/litre the volume should be 0.3 litres
    if from brass/bronze with 8.7 kg/litre the volume should be 0.276 litres.

    If we imagine a very simple cylindrical bulb with a length of 350 mm and a constant circular cross-section (nobody would actually build a bulb like this...) then we can look at the differences in diameter:
    350mm long 2400 g Lead-cylinder has a diameter of 27.7 mm
    350mm long 2400 g Steel-cylinder has a diameter of 33.0 mm
    350mm long 2400 g Brass-cylinder has a diameter of 31.7 mm

    For a more reasonable NACA or other shape I would guess the differences in diameter are similar. I don't know how much of a performance effect this can have - probably very little.

  3. We have been running a similar shape bulb for about 3 years now and seems to perform quiet well. Am curios to know what the reasoning was on the beaver tail shape you are making.

Leave a Reply to Administrator Cancel reply

Your email address will not be published. Required fields are marked *

This site uses Akismet to reduce spam. Learn how your comment data is processed.